Cluster Mode top commands – Basics Netapp – Arkit
Learning Netapp cluster mode is starts here. The very first we have to see cluster mode top commands. To navigate to different directory and commands with in Netapp Cluster mode Command line interface.
In this article we are going to see basic commands of Netapp Cluster mode cd, top, up, set, redo and man usage explanation.
Cluster Mode Top Commands – CD Command
The cd command changes the current working directory of the command prompt to the
directory you specify. Using this command with value “….” will change the directory path to the mentioned value.
cd "storage aggregate"
if you observe above screenshot i have changed the directory path to “volume snapshot”. Using this command we can change the directory path any level directly.
TOP and UP Command
The top command changes the current working directory of the command prompt to the top-level command directory
The UP command will change the current directory to up one level, if you mention (..) it will go two level up in hierarchy.
SET Command
using set command you can change the privilege level of access.
- admin – Used for routine system management commands
- advanced – Used for infrequent, dangerous, or complicated commands
- diagnostic – Used for detailed diagnostic commands that are used only by support personnel
set -privilege advanced set -privilege admin
REDO and MAN Command
redo command will execute the previously executed command without typing total command
man command will give the command usage and its options with details
Please provide your valuable comments.. Is this useful.
Could not give back C-Mode Error
Thanks for your wonderful Support and Encouragement